How to Change Proxy Settings

Specify the proxy server RemotelyAnywhere will use as an intermediary between your web browser and the Internet.

Tip: Proxy servers are primarily used by companies and organizations. Home users generally will not need this option.
  1. Click Preferences to access the host preferences.
  2. Under General Settings, set the following option:
    Option Description
    Broken proxy server mask

    Some proxy servers request pages from web servers using several IP addresses. This can cause RemotelyAnywhere to bounce you back to the login page after you click the Login button. If you are not affected by this problem, you should not change this setting. However, if you experience this problem, please read the following section carefully.

    When you log in, your browser is assigned a session identifier in a cookie. For security reasons, this cookie is only valid when sent from the IP address from which the login originated. Were it not so, an eavesdropping attacker would be able to copy your cookie and gain access to all RemotelyAnywhere resources to which you have access.

    Some proxy servers use several IP addresses when requesting data from a remote computer. If this is the case with your proxy server, RemotelyAnywhere sees the original IP address and session identifier as valid, but requests originating from other IP addresses (even if accompanied by a valid cookie) are replied to with the login page. The login page breaks out of frames, and displays itself in your browser - and you are prompted to log in again. A possible workaround is to keep logging in as many times as necessary - most proxy servers only use a few - maybe half a dozen - IP addresses. Once all the IP addresses are logged in, you will no longer be bounced to the login page.

    Since version 3.2, RemotelyAnywhere has had a setting called Proxy Problem Fixer. This is essentially a mask that can be applied to IP addresses. Suppose your proxy server uses the following IP addresses to request pages from servers: 192.168.0.33, 192.168.0.34, 192.168.0.35, 192.168.0.36, 192.168.0.37, 192.168.0.38

    In this scenario, if you look at the IP addresses in binary form, you can see that only the last three bits are different:

    11000000.10101000.00000000.00100001

    11000000.10101000.00000000.00100010

    11000000.10101000.00000000.00100011

    11000000.10101000.00000000.00100100

    11000000.10101000.00000000.00100101

    11000000.10101000.00000000.00100110

    This means that the largest number that can be represented on three bits (111 binary = 7 decimal) has to be masked from the IP addresses when checking them against each other to verify the validity of the session identifier cookie.

    RemotelyAnywhere provides a subnet mask-like setting for this purpose. By default, it is set to 255.255.255.255 - this means that no bits are masked off. Given the above scenario, we need to mask off the three least significant bits, thus we subtract 7 (binary form: 111) from 255.255.255.255, which leaves us with 255.255.255.248. By entering this value in the Proxy Problem Fixer field, we are telling RemotelyAnywhere to ignore the last three bits.

    This is a rather tedious way of getting around the problem, but short of reconfiguring the proxy server to use only one IP address, there is no easier solution. The latter is the recommended solution, since allowing several IP addresses to share the same session identifier can be a security risk. It is not really significant when you only mask off a few (three or four) bits, but if you need to decrease more and more significant bits of the IP addresses, you are putting yourself in a risky situation. The risk is decreased significantly due to the fact that RemotelyAnywhere now uses HTTPS rather than HTTP by default meaning that the cookie is protected by SSL.

    Broken proxy server mask (IPv6) Select this option if you use Internet Protocol Version 6 (IPv6).
  3. Click Apply. Your settings are applied immediately to the host.